Part I: Self-Registration for a PaperCut Printing Account

These instructions are for non-dcgschools.com account holders to self register for a PaperCut printing account (primarily AEA staff). After creating an account the user should then install the PaperCut Mobility Print client (Part 2).


  1. Connect to the DCG_Wireless school wifi network

  2. Go to http://10.200.0.20:9191/user

  3. Below the “Log in” button click “Guests click here to register”

  4. Enter your first and last name in the Full Name field.

  5. Enter the email for the organization your represent while working at DCG, example: AEA staff would enter their heartlandaea email address.

  6. For username, please use first name followed by last name, note: your full username will start with ext-

  7. Pick a password that is 5-8 characters (numbers only).

  8. For the PIN, enter the same number chosen for the password.

  9. You will need to remember your username and password. This will be required when installing the DCG PaperCut print client.

  10. You do not need to log in the web page.



Part II: Installing the PaperCut Mobility Print Client

Prerequisites:  Username, password/PIN for individual PaperCut user account created through self-registration (Part 1).

  1. Connect to DCG_Wireless network.

  2. Copy and paste this link in your browser: http://10.200.0.20:9163/setup

  3. On the page that loads make sure it says “Set up printing for “ and the type of device you need to set up printing for.

  4. Follow the steps on the page to set up DCG printers.

  5. After they are selected and installed you will need to go to one of your applications to do a test print to complete the setup.

  6. Select the FollowMe_Basic as the printer to print to and click Print.

  7. You will need the PaperCut username and password created during Part I.

    1. Username: ext-firstnamelastname

    2. Password: Password/Pin created in step Part 1, Step 7.


Part III: Associating a Compatible Badge

Prerequisites:  Username, password/PIN for individual PaperCut user account created through self-registration (Part 1).  Compatible badge.

  1. Go to a building copier.

  2. Scan your badge.  

  3. Screen should read “Unknown User”

  4. Enter the PaperCut username and password created during Part I.

    1. Username: ext-firstnamelastname

Password: Password/Pin created in step Part 1, Step 7.